|
|
|
|
|
|
ELASTO-DECK™ 5000MR (Mechanical Equipment Rooms)
|
  
|
Waterproof polyurethane deck coating for foot traffic, resistant to impact, abrasion, vibration from operating equipment, and most chemicals.
For Full Documentation On This Item See Our General Product Index
|
Available Colors:
|
A liquid-applied, single-component, moisture-cured, elastomeric coating system which provides a waterproof, foot traffic bearing deck coating, based on polyurethane elastomers. ELASTO-DECK™ 5000MR is a monolithic system that incorporates excellent adhesion, flexibility, impact resistance. Physical stresses imposed by vibration of equipment will not cause delamination or rupture of the coating. The elastic properties of all system components enable the complete system to give and work with all but the most unusual movement of the floor or deck. The system consists of ELASTO-DECK™ 5001NG base coat, ELASTO-GLAZE™ 6001ALHT top coat, a primer where necessary and an aggregate, if desired for slip resistance.
ADVANTAGES:
- Waterproof elastomeric coating flexes with the floor
- Impact abrasion resistant
- Equipment vibration will not cause delamination
- High shore hardness
APPLICATIONS:
- Durable, tough and abrasion resistant Industrial Flooring
- Slip resistance for foot traffic applications
- Equipment room floors subjected to significant movement due to vibration
SURFACE PREPARATION:
All surfaces which are to receive ELASTO-DECK™ 5000MR system shall be free of contamination such as water, curing compounds, hardeners, bond-breakers, paint, etc. A light broom-finish is recommended for concrete surfaces. It is desirable to watercure concrete in lieu of using curing compounds. Contaminants should be removed by sandblasting or acid-etching. If etching is used, allow adequate time for surface to dry. Except for non-moving shrinkage cracks, all other cracks and joints must be sealed with ELASTO-THANE™ 230. All surfaces must be primed with DECK-THANE PRIMER ™,ELASTO-POXY PRIMER voc ™, OR ELASTO-POXY PRIMER W.B.™ prior to application of the coating systrem at a rate of 250-300 square feet per gallon (7.3-8.6 m2/liter).
APPLICATION:
ELASTO-DECK™ 5001NG shall be applied to the primed surface at a rate of 45 square feet per gallon (1.0-1.1 m2/liter) resulting in a 30 dry mil (.76mm) thickness. After a minimum cure time of 24 hours, ELASTO-GLAZE™ 6001ALHT shall be applied at the rate of 115 feet per gallon (3.0 m2/liter), resulting in a 10 dry mil (.25mm) thickness. The aggregate (No. 20 mesh) is broadcast into the ELASTO-GLAZE™ 6001ALHT membrane at the desired rate, and backrolled, if any slip resistance is needed. The completed coating system shall not be subject to any pedestrian traffic during the first 24 hours after the application has been completed, nor to any heavy traffic of pedestrians during the first four days after application.
|
|
|
